tree adapter

Conveniently bring in trees with the tree adapter.

To do this, the end of the 4 mm plastic rope is attached to the required chains and ropes, then a small aluminum pulley is hooked in and the auxiliary rope is pulled twice to the place of use. The pulley is attached using a webbing sling and the chains are pulled up with the rope.
With this method of operation, efficient use is already possible if only a single tree trunk has to be pulled out of the slope.
The auxiliary winch is powered by the hydraulics of the carrier vehicle and is integrated into the radio control of the forestry cable winch, making it easy to operate. The pulling force of max. 500 kg is sufficient to reach distances of up to 150 m.

In this special case, the plastic rope is then pulled down (up) with the timber cart and remains fixed in the deflection pulley on the log. Once at the winch, simply unhook the 4 mm plastic rope and the hydraulic supply to the auxiliary winch, then pull the load to the storage area!
Then drive back with the carrier vehicle, re-couple the auxiliary winch to the carrier vehicle using the quick-release fastener and reattach the 4 mm plastic cable to the chains and cable of your winch and pull it back towards the deflection pulley to its destination without having to run up or down the slope again unnecessarily!
This method works best when done in pairs!